MATERIALES
1- CUALQUIER BOTELLA (todas resisten 110 P.S.I)
2- Un tubo de agua CPVC (50 cm) y otro (20 cm) ( 130 y 1.130 psi)
3- UN CODO ( 230 y 1.130 psi )
4- TAPA CPVC ( 230 y 1.130 psi )
5- schrader (válvula para bicicleta)
UN INFLADOR O COMPRESORA DE ARIRE/ Inflator, air compressor also serves
PRIMERO
Enrolas el teflon en los tubos, unes los dos tubos al codo, haces un pequeño agujero en la tapa y luego colocas la válvula haciendo presion para que encaje en el agujero, al tubo pequeño le enrollas teflon en la parte media no mucho pero lo suficiente para que haga presion, colocas la boquilla del inflador o compresora en la válvula y la llenas mientras otro sostiene la botella y cuando quiera lo suelta, si quieres mas altura tienes que ir a un grifo para inflarlo con su aire
Wind it in Teflon tubes, two tubes join the elbow, make a small hole in the lid and then put the valve by pressure to fit in the hole, the small tube teflon you wind it in the middle but not long enough pressure to do, put the nozzle of the pump or compressor into the valve and filled while the other holds the bottle and whenever you let go, if you want more height you have to go to a gas station to inflate with air as they have a compressor high pressure.
Wind it in Teflon tubes, two tubes join the elbow, make a small hole in the lid and then put the valve by pressure to fit in the hole, the small tube teflon you wind it in the middle but not long enough pressure to do, put the nozzle of the pump or compressor into the valve and filled while the other holds the bottle and whenever you let go, if you want more height you have to go to a gas station to inflate with air as they have a compressor high pressure.
